Bleeder resistor is made up of 20 - 9K/10 watt resistors in series.  Measured resistance is 182,000 ohm at what would be 200 watts.  The board these are on is good fiberglass with solder tabs left on board and the rest was removed.  The copper materials not needed were removed with a Dremel tool leaving only the solder tabs.  The board measures 6 1/2" x 4 3/4".

NOTE:  The bleeder PC board is held in place by 2 screws into 2- cone-type ceramic insulators at the corners with the connections (marked supporting insulators).  The third screw is into a ceramic insulator which floats, i.e., is not anchored to the mounting board (marked floating insulator).

If this bleeder is replaced, the space available is about 10" x 16 1/2" maximum.  If the filter capacitor is turned 90 degrees on the mounting board, new bleeder resistor space is 6 1/2" x 16 1/2".

Filter capacitor is a rectangular oil-filled 16 mfd at 5000 volts.  It is 3 1/2" high by 4 1/2" wide by 9 1/4" long.  It is mounted with the 4 1/2" x 9 1/4" down.