Even More Info on Modifying Bird Slugs

 

In Sept. of 2006 I was emailing back and forth with a ham in Australia, Steve Darveniza - VK4XRA. I've reproduced several of the messages from Steve as he discovered more about his Bird slug.  Actually it was part of the built-in device in the Bird Termaline 694.  He was able to fix the problem and he gave permission to share his results.

Thanks Steve.



I have found an old bird 694 termaline that is underreading a lot.The load reads 53 ohms on a DMM and the meter reads full deflection 3k ohm. I suspect the diode is broken. Any chance of sourcing a replacement?


Here is what I have learned about the Bird 694 termaline A germanium diode is indeed the way to go,it has to have a forward resistance of 10K OHM or 2.4volt forward voltage this is best, as you will not have to change out the 9.1K OHM series resistor that feeds the 100ua meter,its resistance is 3.0K OHM. So you have a 12.1 K OHM resistance from the meter through the 9.1 K resistor through the germanium diode to earth all is working now but I have to open up the "do not open" movement as the front bearing has let go.


I THINK that a shotky diode is the go, also the meter is now fixed. It is quite easy to get into all you do is get a thin and sharp blade screwdriver and run it around where the black aluminum surround has been folded and it comes off very nicely,then lift off the heavy bezel underneath and then with the widest flat blade you can find, gently apply pressure under the glass whilst watching the black rubber seal moving away from the glass. This particular meter had the actual pointer loose on top of the coil gymble so I just dabbed slow curing super glue under it and repositioned into place and there you have it.


I have finished the last bird 694. The 1N5819 shotky diodes are ideal, also replace the 9.1k ohm carbon resistor with 2 x 18k 1% resistors in parallel and then use your hex key to screw the nylon sleeved RCA jack (capacitive coupling) in or out from the central conductor pin to calibrate the meter. Ensure you do not wind it in so far as for the RCA jack outer to contact the bottom of the post as this will destroy the diode. The calibration is perfect across the whole one kilowatt scale. Very satisfying. I hope this data will help others.


> OK Steve --
> Thanks for that information. I'd like to add it to my
> pages and I'd also like to give you the credit. You're
> not in the witness protection program are you? I'll
> use your name and call.
>
> I wasn't quite sure about your reference to the RCA
> jack and also the hex key. It's been several years
> since I worked on that project but those don't ring
> any bells. Could you have seen that on another
> site? Tell me more.


There is a variable capacitor that couples the rf to the detector diode. This is in the form of what appears to be a RCA jack on a thread that runs into the rf input feed line. This RCA jack can be moved in and out along a centre pin that feeds the diode. This RCA jack has an insulated centre,there is no conductivity. The back centre section of this "RCA jack" has a hexagonal hole for a normal allen key.


Update:  The shotky diode tracks perfectly with the dial scale. I tested the meter on every 5 watt gradation from 5 watts to 1 kilowatt and the design is a credit to the Bird company. It appears the original germanium diodes do deteriorate over the years.


Modifying Bird Slugs

 

This page last modified on 09/25/07 11:44 PM

 Return to Bird Slug pagearrowblu_back.gif (2989 bytes)

Return to Home page  home.gif (1310 bytes)

 

 Page visited 1288 times